diff mbox series

[5/6] arm64: dts: qcom: sc8280xp-x13s: fix touchscreen power on

Message ID 20240423134611.31979-6-johan+linaro@kernel.org
State Superseded
Headers show
Series HID/arm64: dts: qcom: sc8280xp-x13s: fix touchscreen power on | expand

Commit Message

Johan Hovold April 23, 2024, 1:46 p.m. UTC
The Elan eKTH5015M touch controller on the X13s requires a 300 ms delay
before sending commands after having deasserted reset during power on.

Switch to the Elan specific binding so that the OS can determine the
required power-on sequence and make sure that the controller is always
detected during boot.

Note that the always-on 1.8 V supply (s10b) is not used by the
controller directly and should not be described.

Fixes: 32c231385ed4 ("arm64: dts: qcom: sc8280xp: add Lenovo Thinkpad X13s devicetree")
Cc: stable@vger.kernel.org	# 6.0
Signed-off-by: Johan Hovold <johan+linaro@kernel.org>
---
 .../dts/qcom/sc8280xp-lenovo-thinkpad-x13s.dts    | 15 ++++++++-------
 1 file changed, 8 insertions(+), 7 deletions(-)
diff mbox series

Patch

diff --git a/arch/arm64/boot/dts/qcom/sc8280xp-lenovo-thinkpad-x13s.dts b/arch/arm64/boot/dts/qcom/sc8280xp-lenovo-thinkpad-x13s.dts
index b220ba4fba23..e27c8a21125c 100644
--- a/arch/arm64/boot/dts/qcom/sc8280xp-lenovo-thinkpad-x13s.dts
+++ b/arch/arm64/boot/dts/qcom/sc8280xp-lenovo-thinkpad-x13s.dts
@@ -674,15 +674,16 @@  &i2c4 {
 
 	status = "okay";
 
-	/* FIXME: verify */
 	touchscreen@10 {
-		compatible = "hid-over-i2c";
+		compatible = "elan,ekth5015m", "elan,ekth6915";
 		reg = <0x10>;
 
-		hid-descr-addr = <0x1>;
 		interrupts-extended = <&tlmm 175 IRQ_TYPE_LEVEL_LOW>;
-		vdd-supply = <&vreg_misc_3p3>;
-		vddl-supply = <&vreg_s10b>;
+		reset-gpios = <&tlmm 99 (GPIO_ACTIVE_LOW | GPIO_OPEN_DRAIN)>;
+		no-reset-on-power-off;
+
+		vcc33-supply = <&vreg_misc_3p3>;
+		vccio-supply = <&vreg_misc_3p3>;
 
 		pinctrl-names = "default";
 		pinctrl-0 = <&ts0_default>;
@@ -1637,8 +1638,8 @@  int-n-pins {
 		reset-n-pins {
 			pins = "gpio99";
 			function = "gpio";
-			output-high;
-			drive-strength = <16>;
+			drive-strength = <2>;
+			bias-disable;
 		};
 	};